Home  >  Industrial Supplies  >  Industrial Filtration Equipment  >  Other Industrial Filtration Equipment

Environmental electronic Dust catcher, 1.Small size, 2.Easy to install, 3.Low cost, 4.Cleaning effect - details see: https://www.machineto.com/environmental-electronic-dust-catcher-10229815

Company & Product introduction

Anshan Fluid Equipment Manufactory Company Ltd. is a private-owned enterprise with machinery manufacture as its principle field in a vigorous development whose products cover valves of varieties ,envroment protection equipment ,

non-standard metallurgical equipment and its service covers metallurgy, enviroment protection, power, water conservancy , mining.and petrochemical .

The leading valve products cover general vales and special valves of forty sorts and more than 400 sizes such as connection type butterfly valve of quick coupling with self-property right,sealing butterfly valve of hard metal ,various ventilation butterfly valves of wear-resistance and temperature-resistance , water butterfly valves, various dust valves, safety valves, slurr valves ,diaphragm valves ,check valves,and gate valves.

The nominal diameter is DN40--DN 4000mm with the drive mode as manual, electric,worm drive, pneumatic and eletrohydraulic

introduction:

1, the folded filter cartridge of the filter assembly of the device, compared with the ordinary bag, the same diameter and length under the conditions of the filter area is four to five times of the ordinary bag, so under the same amount of wind conditions, dustthe volume of the device can be made smaller, so as to reduce the area and space.

2, due to the small size products, not only transport, easy installation and low construction cost.

Folding cartridge design for the vertical arrangement of the jet pulse jet dust cleaning effect.

4, precipitator set cover top door, easy to change the cartridges, a small amount of maintenance.

5, for low dust concentration occasions, and can be widely used in welding fumes, chemicals, light industrial products, food, pharmaceuticals, metallurgy and other industries. More suitable for the purification of the inlet air.

Commonly known as baghouses, fabric collectors use filtration to separate dust particulates from dusty gases. They are one of the most efficient and cost effective types of dust collectors available and can achieve a collection efficiency of more than 99% for very fine particulates.^[2]

Dust-laden gases enter the baghouse and pass through fabric bags that act as filters. The bags can be of woven or felted cotton, synthetic, or glass-fiber material in either a tube or envelope shape.

Parts

Fabric filters generally have the following parts:

1. Clean plenum
2. Dusty plenum
3. Bag, cage, venturi assembly
4. Tubeplate
5. RAV/SCREW
6. Compressed air header
7. Blow pipe
8. Housing and hopper

Pulse jet

This type of baghouse cleaning (also known as pressure-jet cleaning) is the most common. A high pressure blast of air is used to remove dust from the bag. The blast enters the top of the bag tube, temporarily ceasing the flow of dirty air. The shock of air causes a wave of expansion to travel down the fabric. The flexing of the bag shatters and discharges the dust cake. The air burst is about 0.1 second and it takes about 0.5 seconds for the shock wave to travel down the length of the bag. Due to its rapid release, the blast of air does not interfere with contaminated gas flow. Therefore, pulse-jet baghouses can operate continuously and are not usually compartmentalized. The blast of compressed air must be powerful enough to ensure that the shock wave will travel the entire length of the bag and fracture the dust cake.