Milka-Pro-4 ACR System

Milka-Ware's MILKA-PRO-4 (ACR SYSTEM), is simply the most comprehensive ACR system available.It incorporates world leading technology for management of each cow's milking and provides valuable farmer feedback.

Made in Australia for harsh farming conditions, the system is robust enough to deal with most farming environments. The system is easy to install and maintain.

Milka-Ware is looking for worldwide partners to sell this product in volume. Partners must be able to install the systems and be prepared to provide backup service when required to dairyfarmer customers.

FEATURES

1. Features

Colour Information Screen

No cryptic LED flashing sequences to remember.

– See the milking status of each bail at a glance.

Milking graphs at the milking pointdisplayed where you need it, at the milking point, in full colour. Problem cows,slow quarters, etc can be picked up immediately.

– The flow profile of each milking is

Central Controlnetwork. Adjust parameters, load new software, view milkinginformation. All from a central point without undoing a single screw or adjustinga switch.

– All ACRs are connected to a Master Controller by a highspeed

Central Monitoringwhole dairy at the Master Controller.

– See Kickoffs, put the ACRs into Wash mode for the

Never Obsolete -can be quickly copied to the supplied USB Flashdisk and the entire systemupdated in a few minutes.

– New software for both the Master Controller and the ACRs

Adjustable Slow Takeoffwithout adjusting air bleeds or tubing on each ACR.

– Centrally-adjustable soft takeoff of clusters

Cluster Drop and Retention Barcan be enabled independently with sophisticated control features found only onthe Milka-Pro 4.

– Cluster Drop and retention Bar features

End of Milking Detectionbelow a fixed threshold, resulting in over/under milking depending on howeach individual releases milk. The Milk-Pro 4 includes a special detectionsystem that automatically adjusts the threshold during milking to moreaccurately remove the cups leaving the correct amount of milk in the udder forbetter herd health. Of course fixed threshold and maximum time settings arestill available and can be used in combination as required.

– Ordinary ACRs take off the cups when flow drops

TheMilka-Pro-4works differently to other automatic cup removers. Its flow

sensor is capable of a much wider range of flow measurement allowing more sophisticated end-of-milking detection and display of the flow rate from each cow.

Long overdue in the dairy, the Milka-Pro-4offers a new way to detect end-of milking.Traditional ACRs have a fixed flow threshold which removes the cups when flow drops to that level. Typically the threshold is adjusted for the slower milking cows so they are not cut off too early, which also means fast milking

cows are often over-milked. The Milka-Pro4 now uses average flow to detect end of milking which means treating cows as individuals.