Warm Mist Humidifier Industrial Humidifier 220V/110V ultrasonic humidifier equipment

Ultrasonic Humidifier

l The principle of the Ultrasonic humidifier

Ultrasonic humidification use ultrasonic energy to break up water into small particles of size from a few μms to hundreds μms. This humidifier is not noisy, no pollution, simply operated, equipped with the water protection system, humidity control system and time control system.

II. Installation

1. Install in a clean air environment with little dusts.

2. Connect the output pipe orifice in the main machine with the 110mm PVC pipe, which can lead to the workshop directly, or be punched several holes.

3. A water filter should be equipped before the main machine. Water should be neutral and clean.

4. Water level should be kept around 30mm higher than the surface of the atomizer transducer devices. It influences the atomization if the water level is too high or too low.

III.Notice

1. Don’t move the humidifier and power line when it’s working.

2. Don’t put your hand above the atomizer transducer devices when it’s working.

3. Put the main machine in the place which is ventilated, try to keep away from damp and dust.

4. The water level will change after working for a long time, adjust the water inflow float valve. The water level should be kept 30mm higher than the surface of the atomizer transducer devices.

5. It is better to keep the working time under 10hours everyday.

IV. Technical Parameters:

V. Machine Maintenance

1. Remove the water in tank and the filter cartridge regularly. There will be scale in the water tank after using for a period of time, remove the water once a week as advice.

2. After draining the water, use a piece of clean, wetting soft cloth to wipe off the scale of the atomizer transducer devices.

3. The mist-exit volume may decrease after a long time working, then the atomizer transducer devices need to replace.

VI. Trouble shooting

1. After connecting the power, the indicating lamp doesn’t light, and there is no mist:

(1) The safety fuse may blow out, replace the new fuse of 15A

(2) The air switch is disconnected.

2. The volume of the mist-exit is small while working

(1) The water level is too high or too low

(2) The atomizer transducer device has worked for a long time, clean it or replace it.