MG three-cylinder dryer/ Three Cylinder Rotary Sand Dryer

MG three-cylinder dryer used in the mortar production line

MG Industrial committed to producing green energy-saving products , Innosious and harmless to the operators, pollution free for environment.

1. What’s The three-cylinder dryer?

The three-cylinder dryer is the introduction of European technology, which consists of the three

different diametersc oncentric cylinders, and it Contacts each other together. In the cylinder with

different Angle and distance stripper plate and the guide plate, this structure ensure is drying

materials bygravity along thespiral movement direction, and it keep enough retention time and

sufficient dispersion in the cylinder dryer., that was drying materials in the cylinder from inside the

furnace within andheat flow sufficiently heat exchange.

2. working principle of The three-cylinder dryer:

Special three tube structure, it formed a oneself insulation system through the inside cylinder and the

middle cylinder was surrounded by the outside cylinder, the surface of the inside and middle cylinder

dryer release invoved in the outside layer in the cylinder materials heat exchanger, thus the outer tube

lie in the heat flow low-temperature terminal. So the cooling area and heat loss of the cylinder is

decreased obviously.

3. Application :

The equipment is used for drying yellow sand, slag, clay and other raw materials, widely used in

building material, chemical industry, casting and glass industries etc,

4. Heating method:

It can adapt to the coal, oil, gas and many other fuel.

5. Features :

(1.) Special thermal design concept, eliminate heat loss, increase wind tunnel heat transfer area and

unit volume,

(2.) energy saving effect of good evaporation strength

(3.) Accord with international to create an environment friendly, resource saving social policy, is the

replacement of traditional drying equipment environment friendly products.

(4.) Fuel can adopt to the hard coal, oil and gas.

(5.) Can drying the clumpy and powder material which size is below 20 to 40 mm.,apply to Food, feed,

chemicals, pharmaceuticals, mining and other industries.

(6.) No air leakage, thoroughly solved the seal difficulty

(7.)Initial material moisture content 15%,it's ensure below 0.5-1%. It's the first choice of the Ground

slag, the dry mortar plant and other various drying engineering.

Specifications

Information concerning equipment is updating, and if you are intereted in this products, please contact us for the further more first hand information.