Home  >  Chemical Process Machinery  >  Mixing Equipment

-CE&ISO&IAF&CNAB approved, -high mixing precision, -4-10min one batch, -especially for powder mixing and fluid mixing - details see: https://www.machineto.com/double-horizontal-shaft-forced-mixer-for-powder-and-fluid-high-quality-mixer-approved-by-ce-iso-sgs-iaf-cnab-cqc-10297909

Working principle:

Driven by the directly-connected decelerator, the chains drive the dual-axis rotor to move reversely at a certain speed and, during the movement, the paddle on the axis makes the material go ahead on the one hand and,on the other hand, throws it along with the radial direction to the oblique-front space. The materials on the two sides move in the reversed areas of their own to go to and fro to get direction and are mutually dissolved into the penetrated and mixed so that a fluidized weightless area and rotating vortex is formed in the central part and continually moves along with the axial and radial directions so as to form a full-respect combined cycle to quickly get the uniform mixing effect.

Standard Features:
· Volume: 300-10000L
· Stainless Steel or Carbon Steel
· Ribbon agitator for center discharge
· Designed for normal temperature and normal atmospheric pressure
· Feed Nozzle
· Dust Nozzle
· Manually operated or Pneumatic operated flap valve
· Packing Seal
· Safety limit switch on man hole

Optional Features:
· Carbon Steel, Stainless Steel 304, Stainless Steel 316L
· Sanitary type construction Flap valve, bomb-bay door
· Horsepower to suit higher density materials
· Explosion-proof motors
· Controls such as variable frequency drives, motor starters and operator stations are available
· Spray nozzles for liquid introduction
· High Speed chopper

Matching parts:

A, Mixing Effect
Despite the materials are different in proportion and diameter, it can achieve a good mix effect under the quick and fierce seethe and cast of staggered agitating blades.

B, Crash Device
Crushing device is needed when the material agglomerating. "Crushing Stick" with triangle tooth enclosure maintains high rotating speed of over 1400rpm, which smashes and depolymerizes the agglomerating materials in the material weightlessness area.

C, Discharging Mode
The materials are usually discharged by pneumatic (manual) flap valve. The arc valve can be embedded tightly into the cylinder and be parallelized with inside cylinder wall without material deposit and mixing dead angle. The standard product can be classified into small door and large door that opens to the side of cylinder, delivering clean and quick material charging and little residue.

D, Double Layer Blade
To decrease the replacement costs of easily damaged parts, the paddle blade can be shaped as 2-blade type, on whose base underlaid a movable little blade which can be changed directly, economically and quickly.

E, The Gap Between Blade and Cylinder
The gap between paddle blade and cylinder wall directly affects the mix result and the material residue withinthe mixer after discharging materials; The gap of our products is in range of 3 to 5mm.

F, 20 Cubic Meters Total Volume
This series mixer can conduct complete volume of 203 m at the most. It is significantly different from the general specification in terms of transmission form of large scale device and the base of mixer.