CFKJ508ring die wood pellet Machine

1.Vertical feeding directly in place.

2. Die static, roller rotating, materials centrifugal, Evenly distributed around.

3.Double-layer dies, up and down dual-use, reduce the cost,enhance the efficiency, can be dual-use,high capacity,energy saving.

4.One die,different hole diameters, with different specifications to pelletize.

5.Macroporous die, wire joining circular tube, increasing travel, improving density.

6.Ring die,vertical structure,good for cooling the pelletizing room.

7. Independent and frequency conversion discharge device, to ensure that the rate of

pellet formation.

II.Four differences

1. Upward mould, special structure, vertically feeding and easier heat dissipation.

2. Die static, roller rotating, material centrifugal and distributed around evenly.

3. Double-layer die, multi-function, high efficiency.

4. Macroporous die, wire joining circular tube, increasing travel, improving density.

Scope of application:CFKJ508 vertical ring die granule machine is mainly suitable for crude fiber granulator, such as sawdust, rice husk, rod: cotton, cottonseed hull, weeds and other crops, straw, garbage, waste plastics and waste from factories, adhesive rate is low, it is difficult to molding material granulation, pressing block, bar, can also be used in biological fertilizer, organic fertilizer, compound fertilizer and so on low temperature.

The main characteristics of the CFKJ508 type ring mould pellet machine:

1.the type of pressure roller adopt bevel wheel. And ends with the mold plate, the outer ring line speed, dislocation friction does not appear round and die, to reduce the resistance, reducing energy consumption, prolonging the service life of the die.

2. press roller arranged evenly, smooth operation.

3.the center of pressure regulating structure, adapt to different materials, to ensure the suppression effect. Sawdust, corn straw compression molding takes a lot of pressure, in the same granulation equipment, roller parts are the center of the device components, and the use of high quality alloy steel, increase the service life of roller.

4. the structure template is stationary, the main shaft drives the roller pressing material, suitable for pressing straw particles.

5.the models have a variety of 2--30 mm diameter mould, adapted to different materials, to achieve the best effect.