wood drying machine ( power:4KW)

wood drying machine (capacity:200-300KG/H)

Model: HGJ-I

introducation:

Wood dryer is suitable for drying materials like sawdust, rice hull, milling wheat straw, corn stalks and so on. The moisture of wet materials is at 20-30%. The wood dryer is equipped one fuel boiler, inlet, steel pipe, exhaust blower (fan), cyclone. Wet materials are input into the hopper. The fuel boiler generates hot air which mixes with wet materials and then is sucked into the pipes by the exhaust blower (fan) quickly. And then hot air is flowing and going though the curving pipes and buffer (drying chamber) of dryer, thus wet materials is finished to dry, and the dried materials are expelled out by the exhaust blower (fan). This wood dryer reduces the moisture to 8-12% with the advantages of lower cost consumption and high efficiency.

Principal

It’s used to reduce the unwanted water by the hot air current.Hot air mix with sawdust in the drier and bring some the water from the sawdust.

Flowchart

Burn the heat stove-----Generate hot air-----Start the fan and charge material

Burn the fuel to preheat the tubes. And start the fan. When the hot air teperature reaches about 120°C Charge little material(sawdust) to check if there block or leaking air. If not Charge the material normally.

Cautions

1,The speed of the charging material mainly base on the primary moisture. The charging speed is high when moistuer is low. When the moisture is high the charging speed is low.

2,Every 10 days add lubricating oil to the bearing.

3,Check the tube often, remove the ash blocking the dust removal hole

4,To make sure the material is the sawdust size less than 5*5mm. Commonly before drying the material need separated by the screen to remove big size material.

5,If the impulse jar is blocked open the hole underside to lease the block.

6,The high temparture is prohibited.

7,Discharging material with high temperature is prohibited in case of the fire disaster.

8,Before the production please check if the electrocircuit is correct

Technical data:

Output: 200-300KG/H

Raw materials diameter: <1mm & < 5mm

Temperature of Hot Air: 180°C~250°C

Consumption of Wood Waste: 15-20KG/H

Power (Centrifugal Fan+ Air Lock): 4 KW

Net/Gross Weight: 1000/1100 KG

Package Dimension: 1.5*1.06*1.1 + 2.44*1.22*1.55(m3)

Overall Dimension:6500*1900*3980(mm3)