Surri High Efficency automatic walnut shelling machine/walnut sheller/walnut shelling machine

Surri High efficency automatic walnut shelling machine

1.Brief introduction of Surri High efficency automatic walnut shelling machine

1) This machine is used to crush the hard shell of the walnut. It is suitable for all different sizes of walnuts. But when the size of walnut differs greatly, it is better to grade first.

2) The machine is composed by two parts which is showed in the picture.

3) The machine has its own special transmission system and beating system to make sure the walnut will be broken to remove the shell easily.

2.advantage of Surri High efficency automatic walnut shelling machine

1) Most advanced designed walnut shelling machine, to make sure the walnut will be broken to remove the shell easily and not hurt the walnut kernel.

2) Low damage rate.

3) High shelling rate, can reach to over 99%, almost 100%.

4) Very good quality, suitable to various sizes of walnuts

3.Technical parameters- Surri High efficency automatic walnut shelling machine

4.Installation of Surri High efficency automatic walnut shelling machine :

1. This walnut shelling machine applies three-phase, four-wire system, please connected the earth leakage protection switch. Do not put wrong of the power line and zero line (N is zero line). After connected, please check the work direction first. (conveying chain should be running anticlockwise.)

2. First connecting the power line rightly, then install the charging plate and chute. Otherwise, wrong running direction of the machine will damage the charging chute.

5.Operation of Surri High efficency automatic walnut shelling machine

Put walnuts in the charing plate, open the charing switch (red boat-shape swith), making sure the switch is in half-wave place, adjust the setting knob, when the walnut can outflow along the charging chute to the chain, press the green round switch, now the machine can start working.

Att: charging frequency close to the working speed of the machine is ok. If you require larger breaking fissure, adjust the M10 screw on the top of the machine, anticlockwise, breaking volume will be larger, conversely, smaller.

If the walnut is too hard, backward the heavy hammer behind the flexible pressure head, until the effect is good enough.

6.Maintenance-Surri High efficency automatic walnut shelling machine

1. Put a little cooking oil in the mobile part everyday, open the rear cover of the machine every half month, put some new calcium base grease.

2. If the machine needs to be repaired, do not start up the machine directly after repair. First, open the air shroud of the motor rear cover, stir the fan blade by hand, make sure the running direction is right, then start up the machine.

3. The normal charging chute of the machine applies to walnut within 3-4.5cm diameter. If you need process larger or smaller walnut in large volume, customized charging chute is needed.

7.Sr-60 walnut shelling machine structure

8.Sr-60 walnut shelling machine picture for reference

9.Surri other type walnut shelling machine picture for reference

10.SURRI company service and contact information