silicon steel slitting machine

Steel Slitting Machine Equipment composes:

Uncoiler & Coil Car→Feeder→Crop shear→Front loop table→Side guide→Slitter stand→Scrap winder→Rear loop table→Tension pad→Re-coiler & Coil Car

Come with: Hydraulic system, Pneumatic system,Lubrication system,Electrical equipment

Slitting Line - Automatic Steel Sheet Slitting Machine

Steel Slitting Machine Specification:

Steel Slitting MachineFeatures:

1.By means of programmable logic controller (PLC), system performance is based upon the characteristics of various metal sheets, and switches high/low speed operating mode quaomatically, so as to achieve improved efficiency and reduced maintenance dramatically.

2.Slitting knives are mounted on an integrated frame with a separated transmission, that means enhanced rigidity structure of machine, lower vibration amplitude of knives, and excellent yields could be produced.

Some of Slitting Line Equipment Description:

1.The head of board shears:
1.) Operation features: front-end is cut irregular coil of steel strip to facilitate the orderly access to post-order processing.

2.) Type: We use Dual hydraulic cylinder-driven cutting,
3.) Scissors: SKD-11 high carbon steel blade can be transposed up and down on all sides to use.
2. Disc Shear:
1.) Operation functions: coil vertical cut into the required width. Through the exchange modular sleeve can be flexible and to change the width of the finished cut. DC speed motor drive, stand-alone can be positive inversion. Use of electric side of the boot racks, easy to replace blades.
2.) Type: round knife-type

3.)Disc Shear Mechanical Construction:
a. Circular knife spindle: Material JIS-SCM440
b. Knifeaxis adjustment: adoption of the next shaft, the axis adjustment can be controlled accurately on the axle and lower the gap between shaft.
c. Spindle fastening: the upper and lower knife shaft are used as an axial fastening nut.
d. Knife shaft protection: in the upper and lower spindle shaft with a knife to protect sets of equipment.
4.) Drives: variable speed DC motor DC45KW,distribution gear box, universal joint coupling.
3.Coiler for trimmings:

1.) Operation functions: Coiler for trimmings is locate in both sides of the production coil line, after the steel subsection by the shearing machine

2.) Construction Type: Rotary

Brake device: Air Brake

4.Looper:

1.) The looper’s function is guide the steel into the recoiling machine, when the machine unit operating, control the balance of slitter and winding speed.

2.) Used the hydraulic drive units.
3.) With anti-scratch plastic on surface deposition.

5. Tension generated Station:

1.) Separation of the preceding strip winding machine allows access to pre-strip separation, while after the election of winding strip tension, easy to strip to tighten.

2.) Adjustable tension, tension Station is equipped with a fixed separation device.
3.) In the back of tension station with a long strip speed measuring device to provide signal control line speed synchronization, and display the strip length, provide the basis of sub-volumes.

6.Recoiling machine construction:

1.) Cantilever tape separator: consists of cantilever, separation films, separation packages and separation axis.

2.) Strip steel coiler machine: consists of motors, gear box and coiling block.

The slitting line for reference: