perfessional biomass briquette making machine

wood Energy saving perfessional biomass briquette making machine

Introduction of biomass briquette making machine:

Biomass briquette making machine is widely used in frigid zones as biofuel, raw material of making MDF (Mediumdensity

fiberboard) and other applicable fields as wood chips. It is energy-saving and environmental-friendly, thus it is the best choice to heat in winter and it is very convenient to store.

Features of biomass briquette making machine:

1. Stick shape with different diameter

2. The density, strength and hardness of products are very high.

3. Our briquette machine with higher capacity and lower energy consumption.

4.production moisture is 8-12% ,raw material size below 3-5mm

5.This series of briquette machine is a new type of wood briquette machine,the finished products are

more solid.

6. This Sawdust Briquette Machine with automatic temperature control system is designed to produce

high density wood briquette stick from biomass.

Raw material of wood briquette machine:
1. Raw material: Ground nut shell ,Sugarcane residue Caster Shells/Stalk Saw dust Coffee Husk Paddy Straw Sunflower Stalk Cotton Stalks Tobacco waste Mustard Stalk Jute waste Bamboo Dust Tea waste Wheat Straw Palm husk Soybeans husk Rice Husks Forestry wastes Wood Chips and many other Agro wastes.

2. This machine can be operated 16 hours per day.

3. The extruded wood briquette can be used as fuel for briquette boilers or boilers for heating.

Working principle of biomass briquette making machine

1.fastening bolts, especially in the heating barrel set of three top wire, connecting and electrical power lines.
2 check bearing lubrication part.
3 check the supply voltage is normal.
4 no-load starting running 30 minutes, no card, touch the abnormal phenomenon, can be put into normal production.When the trial revealed abnormalities, should immediately stop, find out the reasons, troubleshooting and then makes no-load operation.
5 the temperature regulator adjusted to the required temperature, when the temperature reaches a predetermined temperature before starting, and amount of feed.
6 gradually increased feeding rate, until the production of qualified products, produced when the normal 30 minutes, can show trial run is successful, the normal operation of.
At the end of 7 to make the hopper feeder with no raw material , and after shutting down the machine immediately reversed for 1 minutes, so that the propeller material would be exit.
The machine body must be well grounded!!!

Mould of biomass briquette making machine:

Final product of wood briquette machine:

About us: