manual 200 (2 fixtures) plastic welder

high quality but low price manual 200 plastic welder, 1.Apply to pe pipe, 2.welder, 3.CE, 4.Light weight and woking efficiently - details see: https://www.machineto.com/manual-200-2-fixtures-plastic-welder-10135114

Condition:New	Place of Origin:Shandong China (Mainland)	Brand Name:BADA	Model Number:SHBDS 200 (2 fixturers)
Input Voltage:220V	Current:50Hz	Power:2.55KW	Dimensions:63mm~200mm
Usage:Welding pipe	Certification:CE	After-sales Service Provided:Engineers available to service machinery overseas	Color:red or blue or other
Warranty:one year	Available welding diameter:63mm,75mm,90mm,110mm,125mm,140mm,160mm,180mm,200mm

contact supplier for manual 200 (2 fixtures) plastic welder

Application:

PEpipes welding machine;

HDPEpipes welding machine;

PPpipes welding machine;

PBpipes welding machine;

PVDFpipes welding machine;

any other plastic pipes available for welding... ...

Further parameters:

Model	SHBDS-160	SHBDS-200
Welding range(mm)	50,63,75,90, 110,125,140,160	63,75,90,110,125, 140,160,180,200
Heating plate temperature	270°C	270°C
Heating plate surface temperature(170-250°C)	<±5°C	<±5°C
Working Voltage	220V,50Hz	220V,50Hz
Heating plate power	1.0KW	1.7KW
Cutter power	0.85KW	0.85KW
Total Power	1.85KW	2.55KW

Our advantages:

The main parts of the machine foraluminum, using standard ZL104, which make working moreenvironmentally friendly and efficiently... ...

The mainelectrical componentsare imported overseas, which are more reliable and stable, extend the life of welding machine and performance more efficiently.

Our machine will be spread alayerof oil, and then be wraped byplastic film,put into awoodenboxat last. This type of packages is avoid getting rusty easily.

we are professional plastic pipe butt fusion welding manufacturer in china.

we can offerlower pricebut the great quality to service our customers.

Operation instruction:

The od card which matches the pipes must be used. Stuck the pipe tightly then fix them on the rack.
Open the ends of pipes,put in the milling cutter, and fix the milling cutter on the rack. Start the milling cutter, mover forward the cylinder,close the fixture and cut the ends. when it forms into thecontinuous chips, lower the pressure to zero firstly, then open the fixture and close the milling cutter at last.
Put down the milling cutter, close the ends, and check up the pipe of the two ends. Check up the temperature of the heating plate. For the first welding, the temperature of the heating plate should be heated over the pre-heated temperature . Every time for welding, the heating plate must be cleaned.
Put the heating plate with the suitable temperature on the rack, close the fixture, make the end meets the end meets the heating plate fully and set the system pressure.
When the end raises uniformly and the height of the crimps meet the requirements, the heating time should be lowered at the same time.
When it get to the endothermic time, open the fixture quickly and remove the heating plate.
Close the fixture quickly, adjust the pressure uniformly in the specified time and write down the cooling time.The pressure should be kept until the ends cool down completely.
When it gets to the cooling time, adjust the pressure to zero, open the fixture, and remove the welded pipe.

ANTICIPATION AND YOUR COOPERATION

Skype ID: miya888269

TEL/FAX: 86-0531-88773369

MOBIILE :86-15098709389