Diesel Engine Governor SY-SC-2032

Diesel Engine Governor SY-SC-2032

1,General desciption

2032 Speed control unit Series Speed Control Unit is rugged enough to be placed in a control cabinet or generator mounted enclosure with other dedicated control equipment. If water, mist or condensation may come in contact with the controller, it should be mounted vertically. This will allow the fluid to drain away from the speed control unit. Extreme heat should be avoided.

2,Installation

Gun Diver Installation sketch map

2.1 Connect Terminal 1 and 2 of actuator to terminal 3 and 4 of battery by cable of 1.5mm2 section or cable of larger section. Long cables require an increased wire size to minimize voltage drops, and especially pay attention to wire pathway when using 12v voltage. Terminal 4 of battery anode should be in series with 10A fuse.

2.2 Speed sensor joints terminal 5 and terminal 6 using double core cable in shield. The shield should be insulated to insure no other part of the shield comes in contact with engine ground, otherwise stray speed signals may be introduced to the speed control unit.

2.3 With the generator stopped, adjust the gap between the magnetic speed sensor and the ring gear teeth. The gap should not be any smaller than 0.020 in. (0.45mm).

VAC RMS during cranking.

2.4 Don’t adjust Speed Control Unit before Diesel Startup, and user adjusts subtly after generator have started.

3, Company image

3.1, Sunyear is a high-tech company specializing in this field for over ten years and got 17 patents.

2.2, Our orientation is intelligent control, we successfully developed the AIS (Artificial Intelligence System) intelligent controllers and Sunyear Power Intelligent Diesel Driven Equipments.

3.3, Wide range of products, including diesel pump, intelligent control system for genset, accessories for diesel engine and genset control system, e.g. engine controller, water pre-heater, automatic voltage regulator, generator synchronizer, genset controller, power factor regulator, fuel solenoid, charger for engine start battery, actuator, speed controller, load sharing panel and so on.

4, Certificate

Our products are approved by ISO9001:2008 standard.