Continuous vacuum belt dryer

1.Main application: The mesh belt dryersis widely used in metallurgy,building materials ,food,light industry,chemicals ,coal ,medicine,and mining industries.

2.Main principle:laid evenly on the mesh belt, driven by the transmission device, the materials move back and forth in the dryer, where hot wind passes through the material and the water vapor is discharged from the weep hole, so as to achieve the purpose of drying.

Mesh belt dryer is used nets with two-way conveying principle, the hot air stove heating or black for drying of medium drying. Namely improve equipment space utilization ratio, and improve ventilation dry conditions.

Mesh belt dryer is composed by the main frame, tail frame, the way among frame, traction chain, nets chain, guide, automatic tensioning device, automatic heating equipment components. The material is the top charging hopper dryer with upper net belt into the dryer, the net belt running smoothly to the dryer, along the chute into the lower, and then back to the machine head, and so on, and the material in the hot air under the baking, gradually dry, by the tail department is sent out.

Mesh belt dryer performance characteristics:

1, with automatic tensioning device, nets with smooth operation, flip freely, and therefore solve the chains, chains, card out running deviation wait for a phenomenon.

2, choose heat-resistant steel braided into screen mesh, high strength, not changeful form, good ventilation.

3, nets brought from speed motor drive, can according to need to adjust the running speed, control the drying time

4 in the dryer, each digital display temperature, it is easy to grasp and control furnace temperature.

5, dryer with maintenance access each section, and is convenient for equipment maintenance.

6, hot air stove heating the only use chain furnace automatic heating equipment, automatic coal, automatic dregs, high thermal efficiency, coal to adapt to the wide, environmental clean, save work time.

7, with fire protection device, kiln head, in the end, a kiln, three thermocouple, 2 flue with smoke gate, once the mechanical failure, immediately put down the gate, partition of heat, prevent fire.

8, the positive pressure hair drier, avoid drying cabinet section and quarter because of lax seal in diameter, into the cool wind, waste heat, causing the waste heat, increase investment cost.

9, design from the upper low temperature area into the material, the low temperature area out of the material, and the material is heated, high low temperature area gradient ramp heat

The low temperature drying the outlet air temperature area more than 100 °C, dust contain is small, induced draft fan, long service life and low operating cost.