competitive grass cutter machine

Hot competitive grass cutter machine for sale with good price

Intrduction of grass cutter machine

1. The lawn machine by the knife dish, engine, wheel, traveling mechanism, the blade, armrest, control parts.

2.. Working principle: the knife dish on the wheel, mounted on the cutter engine, engine blade mounted on the output shaft, use engine high-speed rotating blade, trim on the lawn.

3. The grass cutter machine use conditions:

Below 2000 square meters of lawn, can use hand to push the lawn machines, 2000 or more than 2000 square meters of lawn, can choose self propelled lawn machine, lawn are too many trees and obstacles, you can choose the front universal lawn machine. Larger area, can choose the lawn tractor, generally, 1.07 m (42 inches) lawn machine is suitable for the 12000 ~ 15000 square meters of lawn, 1.17 m (46 inches) lawn machine is suitable for below 20000 square meters of lawn

The grass cutter machine use notice:

Cleaning up

1.Removestones, branches, all sorts of sundry. Mark on the nozzle and the obstacles.

2.Dress: shoes, pants, main is to prevent blade stone splash hurt.

3.Venue: can't cut the grass slope Angle for more than 15 degrees, in case of injury and damage mechanical. Cannot be immediately after rain or watering grass clippings, to prevent slip and mechanical work.

Special emphasis is:

lawnmower operations, 10 meters range, it should not be especially side when the row of side PaiKou not to tell anyone. Adjust the machine and must stop when the grass. Absolutely not adjust when the machine is running mechanical and the grass.

Height adjustment:

According to the requirement of lawn grass clippings of stubble height, warm in the south lawn stubble is commonly 3 centimeters, the penetration of the north stubble height is 5 cm.

Grass clippings when the height of the cut off for a third of the original height of the grass, grass clippings when only along the slope lateral clip, but not up and down the slope trim. Be especially careful when turning on the slope. Beware of caves, groove, mound, and obstacles in the grass.

The safety handle the function and use:

The lawn machine safety control is to control the flywheel brake handle and switch of the ignition coil. Hold the safety control handle, the flywheel brake is released, disconnect switch, gasoline engine can be up and running. On the other hand, let go of the safety control handle, the flywheel is braking, the switch connected to the ignition coil, downtime and put the brakes on gasoline engine. That only hold the security control handle, lawn machine can run normally, when running in case of emergency, the safety control handle to stop the lawn machine. So, run time, never can thread tied up safety control handle.

The grass cutter machine maintenance:

1.)After each job, remove the spark plug, prevent in cleaning up the knife dish, rotating blade engine to start.

2)Check the blade: lawn machine blade often should keep sharp grinding, cut the lawn to flush good-looking, cut grass wound is small, the grass is not easy to get sick. On the contrary, to cut the grass is not good, not only on the lawn machine transmission shaft resistance increase, increasing the lawn machine load, reduce work efficiency, operation temperature, adding machine wear and tear, so to keep blade sharp, improve work efficiency and ensure the normal operation of lawn machine. At the same time, often should check whether the lawn machine blade balance, if the blade is not balanced, will cause the machine vibration, easy to damage the lawn machine parts.

Picture of grass cutter machine