cold-rolled ribbed straightening cutting machine

20000T both sides of the ribs of the cold-rolled high extension production line

A: the features of the cold-rolled ribbed steel heat treatment equipment:

Using the ordinary hot-rolled round bars (Q235) to have it to be cold rolled, after the induction tempering to reach HRB400’s (the newⅡsteel) dimensions and the mechanical properties, better improved the extension rate of the cold rolled ribbed steel and expend the scope of the application of the cold-rolled ribbed steel.

B: BY-1

1. Our equipment uses PLC touch screen CNC system, which simplified the process operating, the higher CNC degree.
2. This production line takes the most advanced International frequency conversion&servo technology or the independent property rights of inverter control technology, effectively protect the transmission and distribution system and the equipment from damage, to be the most to extend the service life of the machine, which could conserve electricity 30% to 40%, the linear speed can up to 90m to 180m, and improved the production efficiency over 40%.
3. The speed reducer we takes is our independent research and development of the national patent product, it is the fastest in our domestic country, simplified the structure of the production and compact (eliminated the reducer between the host rolling milling and the main reducer and reduce problems of the long distance of the reducer conveying and the problems of the deviation of the flange, effectively improve the transmission efficiency over the stability of the equipment improved over 60%and the producing efficiency is greatly improved.
4. Our equipment use ultra audio frequency inductive heating system, spiral induction heating principle, the reinforced will heat evenly, the mechanical indicators of stability, and there will be a blue protective layer in its surface to protect the reel from rust and rot.
5. The straightening machine use multiple rounds synchronous control technique, the straightening effect is well enough and do less damage to the steel bars.
6. The cutting off machine, we take our independent research and development frequency conversion or the servo flying sheer control system, which is easy to operate, the high CNC degree, the low failure rate, the smaller cut off error.

Attention: part of our production line equipment is optional, and it shall prevail with the contact and the packing list.

20000T steel bar production line both sides of the ribs (cold-rolled/high extension)

Introduction of the products:

It is the national patent products, saving 30% to 40% energy, the service life increased by 3 to 4 times, the repair rate is 2 to 3 times lower and the stability of the equipment increased by 60%.

The NC-based model: please assign the product task; we will do the rest to complete them all.

(1) The rolling mill takes the 2 rolling process, to reduce the diameter and the main rolling mill both takes the active synchronous alloy rolls.

(2) The maximum wiring diameter is 16mm, the maximum diameter of the completed products is 14mm, the production quality strictly according to GB13788-2008 and the acceptance of high extension reinforced of the industry standard.

(3) The speed of the rolling mill can be different upon the changeable models form 120m to 180m per minute.

(4) It is the first domestic research and the development of double well up-machine, the two up machine can freely switch and do not need to stop the machine, the total take-up weight up to 2.8t, the appearance of the winding and the third-class steel are exactly the same.

(5) The straight reinforced and the closing lines bounding reinforced can switch freely and do not need to stop the machine.

(6) For the roll use of abrasion: we all takes form the Diamond Brand Plant, according to the steel models the singalslot can produce :φ6/1800t,φ8/1200t,φ9/2600t,φ11/3000t,φ14/5000t.