Automatic Multi-Station nut Former machine

Features of Automatic Multi-Station nut Former machine

1.Connection between the crankshaft and bed as well as the percussion rod all adopts the world-class SKF bearing for assortment, which is of small friction, quick and fiexible operation and saving power.

2.Being cast by adopting the nodular cast iron with alloy contained in the bed, therefore possessing high tensile strength and favorable wear-resistance.

3.The main slide of six-station desk uses the T-type design, thereforethe movement of the slide is much steadier together with one more formed station compared with the five-station, which is more beneficial to process more high-accurate and complex-formed products.

4.The side of main silde adopts the adjustable design to ensure the operation accuracy under the long-term usage.

5.The cropping system uses the guide board to drive the cutting holder,and the guide board reciprocates and the cut off force transmits directly,which is kind of high-powered,stable and good dynamic balance.

6.Equipped with the pneumatic braking, it is fiexible to control and convenient to debug.

7.Configured by the fault detection device and safety protection device, if the equipment is out of order, it will be shutdown automatically, providing a maximum protection to the equipment and tools mode.

8.Installed with the backstop equipment in the feeding box to improve the feeding accruacy.

Machine Detailed Specifications form:

Usage: Make various fasteners especially for auto parts including the non-standard parts & special-shaped pieces etc.

Workshop View:

Steel casing workshop:

Cold forming machine safety operation guide:

1 Wearing gloves to operate cold heading machine is forbidden.

2 All fasteners must be carefully checked whether locked well before driving equipment, safety protection device is whether in good condition, and during working must always examine, prevent loose and cause an accident because of the violent vibration.

3 After the equipment adjusted, first open flywheel, inspect each working parts normal or not,take off pull rod of switch vehicles, and then start motor. It is strictly forbidden to start motor while switch.

4 All fault should be excluded before driving, first short time idle running,and then trial heading.

5 While in motion, the operator should stand in a safe place.Taking workpiece is forbidden at the concave and convex die place, only at the bottom can view products.

6 Carefully adjust the die and punch when replaceing products, , and careful check each part normal or not.

7 In the process of production, if there is failure, must immediately stop, find out the reason, eliminate hidden dangers. If the brakes are broken, it is strictly forbidden to drive.

8 Insurance plate (insurance rod) must add protective device, in order to avoid the fracture accident. All protective device shall not be arbitrary remove, lost.

Company Information: