Home  >  Industrial Supplies  >  Industrial Air Conditioners

air to water heat pump, -Brand Scroll Compressor;, -High Efficiecny and quality heat exchanger;, -Reliable microprocessor system - details see: https://www.machineto.com/air-source-heat-pump-air-to-water-heat-pump-9-8-138kw-for-industrial-air-conditioners-10223419

Air to Water Heat Pump
Air Source Heat Pump
Models: LTWF(R)-10------LTWF(R)-140
Cooling Capacity: 9.8KW----138KW
Heating Capacity: 11.2KW---151.8KW

Introduction:
1. The master module can work independently or together with up to 15 slave modules, capacity from 9kw to 150kw.
2. Units with V type heat exchanger: panels, frame and base are made from galvanized steel protected with polyester powder painting toensure total resistance to atmospheric agents.
3. Units with U type heat exchanger: bearing structure in aluminum, panels in stainless steel, and base in painted section steel.
4. 3-phase scroll type compressor, with built-in thermal overload cut-out and crankcase heater, mounted on rubber vibration dampers.
5. External rotor type axial fans, equipped with three phase direct drive motors, low noise 8 poles, protection level IP54, provided witha protective outlet grille.
6. Evaporator built with high efficiency tube in tube type heat exchanger, factory insulated with flexible close cell material.
7. Condenser built with seamless copper tubes mechanically expanded into blue hydrophilic aluminum fins.
8. Refrigerant circuit complete with charge valves, filter drier, sight glass, gas-liquid separator, thermostatic expansion valve, high & lowpressure switch. The heat pump unit is completed also with 4-way valve, liquid receiver and one way valve.
9. Hydraulic circuit built with galvanized pipe, complete with water discharge connection for tube in tube heat exchanger and flange typehydraulic connectors in two directions easy for connections from both sides of the units.
10. Electric panel consist of: compressor contactor, fan motor contactor, compressor protection breaker, fan protection breaker, phasesequence relay and microprocessor with function display (display only for master/packaged unit)
11. Automatic operation dramatically reducing maintenance cost thanks to reliable microprocessor system.

System Diagram

Configuration Table of LVTE Air Source Screw Heat Pump

Technical Specification for Air to Water(Air Source) Heat Pump LTWF(R)

Notes:

1.Cooling Standard Capacity Working Condition: 12°C water input, 7°C water output, ambient temperature 35°C;
2. Heating Standard Capacity Working Condition: 40°C water input,45°C water output, ambient dry-bulb temp. 7°C, wet-bulb temp. 6°C

3. Heat recovery Device is the optional device for domestic hot water.

Prodcuts in the Factory

Products on the Construction Site

Product Certificates